Help

INTRODUCTION TO DOORS IN APLUS

Inserting doors is one of those things that you need to do in almost every project. Imagine that you can put 10 doors in the same time it takes you to draw one - you can easly achieve that with APLUS.

STEP 1

You can set default layers both for DOORS and for WALLS. These settings will be used whenever you insert door with APLUS. APLUS will insert doors at current layer if you miss this step.

• 
  DRP - Festlegen der Layer für die Türen und die Wand

STEP 2

Inserting door is very simple. Only thing you have to do is to set width and specify two points on the wall, APLUS will do the rest.

• 
  D1 - Türen in den Wänden setzen
• 
  D2 - Setzen von Türen des Typs 2 in den Wänden
• 
  D3 - Setzen von Türen des Typs 3 in den Wänden
• 
  D4 - Setzen von Türen des Typs 4 in den Wänden
• 
  D5 - Setzen von Türen des Typs 5 in den Wänden
• 
  D6 - Setzen von Türen des Typs 6 in den Wänden

STEP 3

So you have inserted doors into your drawing, but you realize that some of them are inserted in wrong direction. You do not have to repeat inserting. Instead just use DFL command to flip selected door.

• 
  DFL - Tür versetzen

WHAT TO DO IF INSERTING DOOR BREAKS AXIS LINE?

Sometimes you need to insert door on wall, that contains elements which you wish to save from breaking. You can either lock them with LLL command or turn off with LLO command.

• 
  LLL - Ausgewählte Layer schließen